American Electric Power Fleet Technician B in San Angelo, Texas
Fleet Technician B
Perform maintenance/repairs on sedans, light/medium/heavy trucks, trailers and heavy work equipment and any attached equipment, and/or auxiliary equipment, which is part of the specialized vehicles, operated by the Company. The following list sets forth the principal duties required for the job. This list is not intended to limit assignment of work or the degree of supervision under all operating conditions. Employee may perform miscellaneous, related, and incidental work in addition to that specifically outlined below. Service and repair boom/pedestal assemblies of the Company's specialized equipment including troubleshooting equipment; inspect cables, chains and rods; inspect sheave liners; inspect and repair monitoring system; inspect fiberglass components; inspect turntable; remove and replace reduction gearboxes; inspect pins, bushings and bearings; and load test boom assemblies. Service and repair hydraulic systems including troubleshooting the hydraulic system; inspect, remove and replace hydraulic pumps, motors, valves, cylinders and the accumulator; and remove and replace swivel collector block. Service and repair heating and ventilation systems including diagnose A/C unit problems; conduct pressure test on A/C unit; check for leaks using appropriate devices; check internal system controls; replace compressor; service A/C clutch assembly; and replace compressor seals, refrigerant hose, condenser assembly, receiver dryer, and evaporator core. Troubleshoot and repair winch assemblies. Service and repair the steering system of Company vehicles including repair power steering pump and manual steering gearbox. Service and repair the air brake systems of Company vehicles including air compressors, air brake chambers, and air control valves. Service and repair hydraulic and electric braking systems including inspect and repair master cylinder; test power unit and vacuum supply; inspect power boost system; repair power brake system; and service and repair antilock brake system. Inspect and service differentials and power dividers. Inspect and service transmission assemblies of Company vehicles including manual clutch, manual transmissions and transfer cases, transaxles (front-wheel-drive), and automatic transmissions. Service and repair the fuel and exhaust systems including computer control system; test and repair diesel fuel pump; inspect and service intake and turbo system; service and repair fuel injection system (gas/diesel); and inspect and service governors. Assist others in the diagnosis of more complex problems. Operate Company vehicles and associated equipment and perform duties incidental to the operation of such equipment. Perform duties in accordance with the Company's safety rules, regulations and practices and report unsafe conditions and practices. Maintain tools, equipment and work area in a clean and orderly condition. Maintain records and submit reports as required. Attend and participate in training as assigned and assist in the training of other employees. Perform less skilled work as assigned. Report irregularities and abnormal conditions. Assist employees of equal or higher classification. Direct the work of employees assigned to assist.
Auto req ID:
San Angelo, TX
Transportation and Warehousing
Education: High school graduate or GED required. Experience: At least 2 years of strong automotive mechanical diagnosis with hydraulic and diesel repair experience. Graduation from an automotive trade school with diesel engine experience is highly desirable. Licenses/Certifications: Must possess and maintain a valid state driver's license. Must obtain Class A CDL within 6 month of entry date into the Fleet Technician B classification or vacate the job classification. Must obtain Fluid Power Society Certification and two (2) applicable ASE certifications within 24 months of entry date or vacate the current job classification. Other Requirements: Successful completion of the Tuff Tech pre-employment placement test is required for this position. Must qualify through demonstration, examination and/or performance appraisal as determined by the Company. Must exhibit competency and aptitude in the fundamentals and mechanics of vehicle maintenance and repairs. Must become familiar with and have the ability to operate the computer systems utilized by the Fleet Services organization. Must acquire within such time frame as determined by the company, the qualifications necessary to perform the duties of the Fleet Technician A, or vacate the current job classification. For Fleet Techs that support Transmission, travel of 80% ? 100% may be required. Shift work may be required Physical Demands: 1. Work at heights ? climbing ladders and on/in large trucks and equipment 2. Frequent use of hand tools including various heavy equipment for repairs, ability to grasp, push, pull 3. Ability to lift up to 100 pounds, working in awkward positions, working overhead 4. Frequent walking, standing on concrete and occasionally in rough terrain 5. Ability to operate trucks and heavy equipment
Equal Opportunity Employer | Minorities/Females/Disability/Vets